HP LH4r HP Netserver LXr Pro8 Memory Board - Page 25
At the rear, insert the satellite chassis. To do so, push in the release
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Chapter 2 Installing Memory in the 4 GB Memory Board 6. Reattach the lower fan module: a. On each side of the back of the fan module are two slots. Line these slots up with the flanges on the fan's mounting rails. b. Push the fan module onto the mounting rails until it clicks into place. 7. Reattach the satellite chassis to the base chassis: a. When you finish servicing the HP NetServer, move to the front of the server and unlatch all four power supplies. (If the front bezel is in place, remove it.) b. At the rear, insert the satellite chassis. To do so, push in the release latch for each slide (Figure 2-14). While holding the latches down, push the satellite part way onto the base, so that the latches can no longer engage. Push down the release latches on each slide. Then push the satellite partly onto the base chassis. Release Latch Figure 2-14. Unlocking the Slides c. If you do not depress these two latches, the satellite cannot move all the way onto the base chassis. 21