HP LH4r Installing Caldera eServer on an HP Netserver - Page 1

Caldera OpenLinux Server 3.1 Installation Guide for HP NetServers NOTICE: The information in this document was last updated for the HP NetServer Navigator CD-ROM version M.04.05. If you don't have the M.04.05 version CD-ROM and you're obtaining this document from the HP web site as a reference to install an operating system, be sure to also check the HP web site for the latest available drivers. ©Copyright Hewlett-Packard Company (This document is only available in English.) November 3, 2001 (Rev: 20011103) Introduction This document was created by Hewlett-Packard for the purpose of helping you install Caldera OpenLinux Server 3.1 on your HP NetServer, based on procedures tested by HP. The objective of this document is to provide the information needed to achieve the following tasks. · Install Caldera OpenLinux Server 3.1 from CD-ROM. · Configure network settings. Features Caldera OpenLinux 3.1 includes the Linux 2.4 kernel, XFree86 4.0, KDE 2, and a number of security features that significantly enhance OpenLinux out-of-the-box security. These security-related features include OpenSSL, OpenSSH, Tripwire, PortSentry, and enhancements to the Apache HTTPD server. Requirements CPU: Caldera OpenLinux 3.1 includes the 2.4 kernel compiled to support up to 64GB of RAM. As a result the kernel and Caldera OpenLinux will only function on systems that support the PAE (Physical Address Extensions) standard. Such CPUs include the following: · Intel Pentium III · Intel Pentium 4 Disk Space: A full installation of Caldera OpenLinux 3.1 requires 1700 MB.