HP LaserJet Enterprise flow MFP M830 User Guide 1 - Page 72
Install or replace the booklet maker or booklet maker hole punch accessory for the HP Color LaserJet ..., Introduction, Before you begin, Required tools
View all HP LaserJet Enterprise flow MFP M830 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Install or replace the booklet maker or booklet maker hole punch accessory for the HP Color LaserJet Enterprise M855 and HP Color LaserJet Enterprise flow MFP M880 ● Introduction ● Before you begin ● Required tools ● Step one: Remove the booklet maker ● Step two: Unpack the optional or replacement booklet maker accessory ● Step three: Install the optional or replacement booklet maker accessory ● Step four: Parts return ● Step five: Configure the booklet maker in the Embedded Web Server (EWS) ● Step six: Configure the default hole punch location ● Step seven: Configure the default staple location Introduction The following information provides the procedures to install or replace a booklet maker for the HP Color LaserJet Enterprise M855 and HP Color LaserJet Enterprise flow MFP M880. Before you begin Use the table below to identify the correct accessory part number for the accessory, and then go to www.hp.com/buy/parts. Table 2-4 Booklet maker/finisher accessory part numbers A2W83A A2W84A Booklet maker/finisher accessory with installation instructions Booklet maker/finisher with 2/3 hole punch accessory with installation instructions CZ999A Booklet maker/finisher with 2/4 hole punch accessory with installation instructions To replace an existing booklet maker, go to Step one: Remove the booklet maker on page 65. To install a new booklet maker, go to Step two: Unpack the optional or replacement booklet maker accessory on page 66. Required tools No special tools are required to install this accessory. 64 Chapter 2 Install and configure the finishing accessories ENWW