HP LaserJet Managed MFP E82540-E82560 Engine Install Guide - Page 1
HP LaserJet Managed MFP E82540-E82560 Manual
View all HP LaserJet Managed MFP E82540-E82560 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
HP LaserJet Managed Flow MFP E82540-E82560 ( ( Engine Install Guide support.hp.com NJ OE www.hp.com/videos/A3install HP recommends reviewing the video before performing the installation. WARNING: Make sure the work area is free of debris and the floor is not slippery or wet. CAUTION: The printer assembly is heavy. Four people must lift and install it on the dual cassette feeder (DCF) (Y1F98A), the 2000-sheet high capacity input (2000-sheet HCI) (Y1G21A), or the stand (Y1G16A). 1 Unpack and acclimate the printer. CAUTION: Before the printer is powered on, make sure that the room and equipment are at least 15°C (59°F). NOTE: Leave the printer on the shipping pallet until it is ready to install on a DCF, 2000-sheet HCI, or stand. 1.1 Remove the printer, imaging drum, toner collection unit (TCU), and associated hardware from the box. After unpacking the printer and supplies, allow them to acclimate for four hours. NOTE: If the printer and hardware were stored below 0°C (32°F), it may take them longer to acclimate. CAUTION: Do not remove the shipping tape or protective packing materials until after the printer is installed on a DCF, 2000-sheet HCI, or stand. (Step 3.5) NOTE: The imaging drum is stored in the output bin area below the automatic document feeder. 1.2 Pull the protective clear plastic down to the base of the printer to allow access to lifting points. 1