HP LaserJet Managed MFP E82540-E82560 Engine Install Guide - Page 2
Install the printer on the DCF, 2000-sheet HCI, or stand., Prepare the DCF, 2000-sheet HCI, or stand
View all HP LaserJet Managed MFP E82540-E82560 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
2 Prepare the DCF, 2000-sheet HCI, or stand for installation. CAUTION: Use care when lifting. Use proper safe lifting practices. IMPORTANT: Retain two thumbscrews for securing the HCI or stand. 2.1 Follow the in-box directions to unpack the DCF, HCI, or stand. 2.2 Position the DCF, HCI, or stand near the printer. WARNING: Make sure the work area is free of debris and the floor is not slippery or wet. NOTE: If desired, lower the stabilizers to prevent the printer from moving. 3 Install the printer on the DCF, 2000-sheet HCI, or stand. 3.1 Install the two black reusable lifting handles in the hand holds on the left side of the printer (callout 1). Open two lift bars on the right side of the printer (callout 2). NOTE: Lifting handles are recommended, but are not shipped with the printer (handle set: JC82-00538A). 3.2 Carefully lift the printer assembly and align the printer to the alignment pins and connector on the accessory. Carefully lower the printer onto the accessory. CAUTION: The printer assembly is heavy. Four people must lift and install it on the DCF, the HCI, or the stand. NOTE: On the printer, open each door and all of the trays to check for shipping tape and packing materials. Remove all shipping tape and protective packing materials. NJ OE 3.3 Remove the trays and install two thumbscrews (retained in step 2). 3.4 Remove the scanner lock screw and red sticker on the left side of the printer. WARNING: The scanner lock screw must be removed prior to powering on the printer. 2 3.5 Remove all tape and packing materials. Make sure to check Tray 1, Tray 2, and Tray 3.