HP LaserJet Managed MFP E82540-E82560 Engine Install Guide - Page 7

11 Late point differentiation configuration (LPDC) checklist (manually using USB flash drive). • Make sure that the network cable is disconnected from the printer. • Turn on the main power switch (near the power cord), and then press the power button on the front of the printer to turn the power on. • Download the speed license to a USB flash drive. • With an internet-connected PC, open a browser and go to the HP Jet Advantage Management (JAM) Activation site: https://activation.jamanagement.hp.com • Select the country/region. • Select SIGN IN on the Partner First Portal. • Type the HP Passport sign-in credentials (including the User ID and Password). • Select Managed Print Specialist. • Select Technical Support. • Select Activate License. • Search for License. • Enter the Serial Number and Printer Product Number. • Select Submit. • Select the Get License button next to the device serial number to download the LPDC license file. NOTE: If the license is not found, contact your distributor to ensure HP has been sent the information to create the license. Once HP has created the license you will need to wait 24-48 hours before the license becomes available in the cloud. CAUTION: Licenses must be saved in the root directory of the USB drive with the specified file name. • Save the file to the root directory of the USB flash drive that has been FAT32 formatted. • With the printer at the Ready state, insert the USB flash drive into the walk-up USB port on the printer (formatter or HIP USB). • M ake sure that the control panel acknowledges that a USB flash drive is installed (a quick message appears on the control panel). Then, press the power button on the front of the printer to turn the power off. • Press the power button on the front of the printer to turn the power on, and then wait for the printer to reach the Ready state. NOTE: If the USB flash drive is not detected, remove the USB flash drive, turn the printer power off, reinsert the USB flash drive, and then turn the printer power on. • Wait for the LPDC process to automatically start (within 10 minutes of having a working internet connection). NOTE: The printer reboots after the LPDC process is complete, and then the printer setup wizard starts. • When the Setup Wizard appears, reconfigure each of the settings. • Wait at least 5 minutes after the printer comes to a Ready state to allow the LPDC process to complete. CAUTION: Do not turn the printer power off during this time. • Print another configuration page and make sure that the LPDC is configured with the correct license speed and that the printer model number is correct. The printer product model changes to the ordered model number. In the LPDC status, the first number in the parentheses (x) is either "0", "1" or "2". The "0" corresponds to the slowest speed, "1" is the middle speed, and "2" is the fastest speed. This confirms that the LPDC process is complete. • Connect the network cable. NOTE: If the manual license transfer fails, contact your distributor for support. 7