HP Latex 3200 Introductory Information - Page 11

English Message or code Checking file system Checking printer Clean drop detector spittoon Cleaner roll jam Color calibration canceled because of scanning errors Connecting Connecting printer, please wait Disconnected FW upgrade post actions Ink drying Ink system not ready to print Job canceled due to lack of data received from the IPS Line sensor calib. error: substrate too small Low cleaner roll Lower lever Maintenance #N advised. Please contact HP. No substrate loaded Please close safety sensor Please press rearm button Please release emergency stop Preparing to print Recommendation After a dirty power off, the printer performs a file system check, which will take some minutes. The printer is completing checks and cool-down cycle after finishing a job. Clean the ink deposits. Go to the Internal Print Server and select the Ink System menu, then Check cleaner roll. Pull out the printhead cleaning roll assembly, raise the pinchwheels, wind the roll forward manually, then lower the pinchwheels and push the assembly back into the printer. The color calibration chart could not be scanned successfully with the current substrate. The Internal Print Server is connecting to the printer. The Internal Print Server is starting the printer. The printer is shut down or not detected. A firmware update is being performed. The printer is drying the last passes of a job after printing it. Please wait a while. If the printer does not recover, restart it. If the problem persists, check the configuration of the built-in computer, which runs the Internal Print Server. Load a larger substrate. Be ready to replace the printhead cleaning roll soon. Lower the substrate pressure handles. You are advised to contact your service representative. Load substrate. An open safety circuit has been detected, and should be closed in order to continue working. Press the blue, blinking button to finish the printer's start-up procedure. An emergency button has been pressed, and must be released to continue working. The printer is performing checks and warm-up prior to printing. ENWW 7