HP Latex 3600 Users Guide - Page 23
Move the printer, IMPORTANT, CAUTION
View all HP Latex 3600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Level Turn off Turn on 1: Major power electronics and engine off. Wait for the Internal Print Server to indicate that the printer is ready, then turn off the high-power subsystems by pressing the shutdown icon near the top left corner of the screen. Wait until the Internal Print Server reports that it has lost its connection to the printer. Click the Wake Up button up in the top left corner of the Internal Print Server window, and wait for the printer to turn on the high-power systems. When prompted, press the blue rearm button at the front right of the printer. NOTE: After the printer electronics have been turned off at the Internal Print Server, the fans turn at maximum speed for safety reasons. This is normal behavior and not a cause for concern. 2: All printer systems off After completing level 1, turn off the main switch. The After completing level 1, turn on the main switch, and (recommended). fans should stop. ensure that the circuit breaker beside it is on. When prompted, press the blue rearm button and wait for the Internal Print Server to announce that the printer is Ready. 3: All printer systems and Internal Print Server off. After completing level 2, shut down the Internal Print Server from the Windows Start button, and wait until you see a black screen with the message No input signal. After completing level 2, see Turn on the printer for the first time on page 16. CAUTION: The computer may be damaged if it is turned off incorrectly. Once the Internal Print Server is completely off and you see No input signal on the screen, turn off the computer power switch. 4: Reboot. - - 5: Reboot and print. - - IMPORTANT: The printer incorporates a counter that indicates the printer usage time that remains. Move the printer If you wish to move the printer a short distance on the same site, across a horizontal floor with no steps and no slopes of more than 5% inclination, see the following instructions. For more difficult movement operations, call your service representative (see HP Customer Care Centers on page 409). CAUTION: Slopes steeper than 5% may cause serious damage to the printer. 1. Turn off the printer. 2. Disconnect all power and network cables from the printer. 3. Disconnect all ink cartridges and remove them from the printer. Hold the cartridge connectors in position with adhesive tape. 4. If your printer is an HP Latex 3500/3600, raise the secondary feet before moving the printer. 5. Is your printer is an HP Latex 3500/3600, unload the split spindles and remove both center support split spindles from their base (see HP Latex 3500/3600 dual-roll split spindles center support on page 63). 6. Raise the feet so that the wheels (A) touch the ground. To raise a foot: ENWW Move the printer 17