HP Latex 850 Users Guide - Page 44
geared end of the spindle should be on the right.
View all HP Latex 850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
7. Open the latches at both ends of the spindle (if they were closed) and push the roll on its spindle into the printer. 8. Close the latches to secure the spindle in place. TIP: If you cannot close the gear side latch, try sliding the spindle towards the side plate to make sure the end flange is not sitting on the bearings. 9. In the same way, load the spindle with the empty core into the front of the printer. In this case, the geared end of the spindle should be on the right. 10. Check that the printer has finished raising the carriage beam. 11. Check that the curing plates are in the correct position for the substrate you are loading (see The curing plates on page 32). 12. Pass the leading edge of the substrate through the printer to the output roll. Handle the substrate 40 Chapter 3 Handle the substrate ENWW