HP M3035xs HP LaserJet M3027/M3035 MFP - User Guide for Model Numbers CB414A/C - Page 40
Initial Setup menu, Networking and I/O
UPC - 883585038534
View all HP M3035xs manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Initial Setup menu The Initial Setup menu contains the sub-menus shown: ● Networking and I/O menu ● Fax Setup menu ● E-mail Setup menu NOTE Values shown with "(default)" are the factory-default values. Some menu items have no default. Networking and I/O Table 2-9 Networking and I/O Menu item I/O Timeout Sub-menu item Parallel Input NOTE This item appears only if an EIO accessory is installed. High Speed Advanced Functions Values Description Select a value in the range. The factory default setting is 15 seconds. I/O timeout refers to the elapsed time before a print job fails. If the stream of data that the device receives for a print job gets interrupted, this setting indicates how long the device will wait before it reports that the job has failed. No Yes (default) Enabled (default) Disabled Use the High Speed setting to configure the speed that the parallel port uses to communicate with the host. Use the Advanced Functions setting to enable or disable bidirectional parallel communication. Embedded Jetdirect EIO Jetdirect See Table 2-10 Jetdirect menus for the list of options. Table 2-10 Jetdirect menus Menu item TCP/IP Sub-menu item Enable Host Name IPV4 Settings Sub-menu item Config Method Values and Description Off: Disable the TCP/IP protocol. On (default): Enable the TCP/IP protocol. An alphanumeric string, up to 32 characters, used to identify the device. This name is listed on the HP Jetdirect configuration page. The default host name is NPIxxxxxx, where xxxxxx is the last six digits of the LAN hardware (MAC) address. Specifies the method that TCP/IPv4 parameters will be configured on the HP Jetdirect print server. Bootp: Use BootP (Bootstrap Protocol) for automatic configuration from a BootP server. DHCP: Use DHCP (Dynamic Host Configuration Protocol) for automatic configuration from a DHCPv4 server. If selected and a DHCP lease exists, DHCP 28 Chapter 2 Control panel ENWW