HP MSL4048 HP StorageWorks MSL2024, MSL4048 Tape Library Fibre Channel Referen - Page 10

Configuring the library HP StorageWorks MSL2024 tape library NOTE: HP recommends that you cable Port A only and that you configure Port B for Auto Detect on Fibre Speed and Port Type. 1. From the Home screen, press Previous or Next until the screen displays Configuration. Press Enter. 2. Press Previous or Next until the screen displays either Change Drive 1 or Change Drive 2. Press Enter. 3. Enter the Administrative password if prompted. 4. The screen displays Port A. Press Enter to select and display Fibre Speed. 5. Press Enter to display Set Fibre Speed. Press Previous or Next to toggle through the speed settings (1 Gb, 2 Gb, or Auto Detect). Press Enter to select the required speed. 6. The screen displays Port Type. Press Enter to display Set Port Type. Press Previous or Next to toggle through the port types (Fabric (N), Loop (NL) or Auto Detect). Press Enter to select the required port type. 7. If you have selected Fabric (N) or Auto Detect, configuration is now complete, go to step 9. If you have selected Loop (NL), Set Port Loop Mode is displayed. Press Previous or Next to toggle through the loop modes (soft, Hard or Hard Auto Select). Press Enter to select the required loop mode. 8. If you have selected Soft or Hard Auto Select, configuration is now complete, go to step 9. If you have selected Hard, Set ALPA is displayed with the first number flashing. Press Previous or Next until the flashing number reads correctly. Press Enter to move to the next number. Repeat this step until all numbers in the address are correct. Press Enter. 9. Press Enter to save the settings and reset the port. 10.Display Port B. 11.Press Enter to select and display Fibre Speed. Select Auto Detect. Press Enter. 12.Press Enter to select and display Port Type. Select Auto Detect. Press Enter. 8 Installation and configuration