HP Microportable Projector MP1600 Compaq MP1600 Microportable Projector User's - Page 15

Powering On the Projector, the Check Video Cable

Get HP Microportable Projector MP1600 PDF manuals and user guides View all HP Microportable Projector MP1600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

Be sure to place the rubber boot cover over the DFP (digital) connector on the projector when it is not in use to prevent electrostatic discharges from damaging the connector. Powering On the Projector Follow these instructions to power on the projector: 1. Ensure that the power cord and signal cable are securely connected. Make sure the projector is perpendicular to the screen. 2. Remove the lens cap 1 by pulling it straight out. 3. Turn on the Main power switch 2 on the back of the projector and allow the projector to warm up for 1-2 minutes. When the projector has warmed up, the Compaq startup screen will display and the LED on the Standby button 3 will turn green. When the startup screen disappears, the video from the attached computer will display. If there is no incoming video, the "Check Video Cable" message will display on the projection screen.   MP1600 Microportable Projector 1-9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
MP1600 Microportable Projector
1-9
Be sure to place the rubber boot cover over the DFP
(digital) connector on the projector when it is not in use to
prevent electrostatic discharges from damaging the
connector.
Powering On the Projector
Follow these instructions to power on the projector:
1. Ensure that the power cord and signal cable are securely
connected.
Make sure the projector is perpendicular to the screen.
2. Remove the lens cap
1
by pulling it straight out.
3. Turn on the Main power switch
2
on the back of the projector
and allow the projector to warm up for 1-2 minutes.
When the projector has warmed up, the Compaq startup screen
will display and the LED on the Standby button
3
will turn
green. When the startup screen disappears, the video from the
attached computer will display. If there is no incoming video,
the “Check Video Cable
”
message will display on the
projection screen.