HP Microportable Projector MP1600 Compaq MP1600 Microportable Projector User's - Page 31

Special On-Screen Messages, Check Video Cable, Input Signal Out of Range, Inputs Active - Remove One

Get HP Microportable Projector MP1600 PDF manuals and user guides View all HP Microportable Projector MP1600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

Special On-Screen Messages Special on-screen messages will appear on the projection display to identify the following conditions: s Check Video Cable: Indicates the video cable may not be plugged into the projector or the selected video input is not accurate. s Input Signal Out of Range-Indicates the projector is unable to access the appropriate input signal. s 2 Inputs Active - Remove One-The projector has two data inputs: one is an analog D-Sub input and the other is a digital DFP input. This message indicates that both inputs are active simultaneously and the user should detach one of them. s Going to Standby-Indicates the projector is entering a sleep mode or is powering off the lamp. s Lamp May Fail Soon, Replacement Suggested-Indicates the lamp is approaching failure. The message will remain on the screen for five seconds or until the on-screen menu Select button is pressed.   MP1600 Microportable Projector 1-25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
MP1600 Microportable Projector
1-25
Special On-Screen Messages
Special on-screen messages will appear on the projection display
to identify the following conditions:
■
Check Video Cable:
Indicates the video cable may not be
plugged into the projector or the selected video input is not
accurate.
■
Input Signal Out of Range—
Indicates the projector is
unable to access the appropriate input signal.
■
2 Inputs Active - Remove One—
The projector has two data
inputs: one is an analog D-Sub input and the other is a digital
DFP input. This message indicates that both inputs are active
simultaneously and the user should detach one of them.
■
Going to Standby—
Indicates the projector is entering a sleep
mode or is powering off the lamp.
■
Lamp May Fail Soon, Replacement Suggested—
Indicates
the lamp is approaching failure. The message will remain on
the screen for five seconds or until the on-screen menu Select
button is pressed.