HP Mini 110-4100ca HP Mini 210, HP Mini 110, Compaq Mini CQ10 - Maintenance an - Page 76
Remove the two rubber feet, on the rear corners of the base enclosure. The rubber feet are
View all HP Mini 110-4100ca manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
3. Release the ZIF connector (1) to which the TouchPad cable is connected, and then disconnect the TouchPad cable (2) from the system board. NOTE: Additional slight force may be needed when releasing the TouchPad cable from the top cover. Double-sided adhesive is used to attach the TouchPad cable to the top cover surface. 4. Remove the two rubber feet (1) on the rear corners of the base enclosure. (The rubber feet are available in the Rubber Kit, spare part number 650734-001.) 68 Chapter 4 Removal and replacement procedures
3.
Release the ZIF connector
(1)
to which the TouchPad cable is connected, and then disconnect the
TouchPad cable
(2)
from the system board.
NOTE:
Additional slight force may be needed when releasing the TouchPad cable from the
top cover. Double-sided adhesive is used to attach the TouchPad cable to the top cover surface.
4.
Remove the two rubber feet
(1)
on the rear corners of the base enclosure. (The rubber feet are
available in the Rubber Kit, spare part number 650734-001.)
68
Chapter 4
Removal and replacement procedures