HP NetServer AA 6200 HP NetServer AA 6200 Solution Release 3.0 Administrator&a - Page 102
CE Show Auto Boot, Show Auto Boot From IOP
View all HP NetServer AA 6200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Chapter 5 Commands CE Show Auto Boot This command shows the state of the Auto Boot parameter for a specific CE. Auto Boot allows the CE to automatically boot the CE's Windows NT operating system after a reboot or power cycle. By default, Auto Boot is true (enabled). Command CEn Show Auto Boot From IOPx Console Syntax MTCCONS CEn Show Auto Boot From IOPx Variables n - the ID number of the CE (1 or 2) x - the ID number of the IOP (1 or 2) Results The value for Auto Boot is displayed as either: true (enabled) or false (disabled). For an example of the results of this command, refer to CE Show Parameters (page 88). See Also CE Disable Auto Boot CE Enable Auto Boot CE Show Parameters CE Show Auto Synch This command shows the state of the Auto Synch parameter for a specific CE. Auto Synch allows the CE to automatically synchronize with the other CE after a reboot. If you disable Auto Synch, you cannot synchronize that CE until you issue a CE Enable Auto Synch command. By default, Auto Synch is true (enabled). Command CEn Show Auto Synch From IOPx Console Syntax MTCCONS CEn Show Auto Synch From IOPx Variables n - the ID number of the CE (1 or 2) x - the ID number of the IOP (1 or 2) Results The value for Auto Synch is displayed as either: true (enabled) or false (disabled). For an example of the results of this command, refer to CE Show Parameters (page 88). See Also CE Disable Auto Synch 86