HP NetServer AA 6200 HP NetServer AA 6200 Solution Release 3.0 Administrator&a - Page 124
Reset Partition
View all HP NetServer AA 6200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 124 highlights
Chapter 5 Commands IOPn.Diskx Reset Partition Warning: Using this command may cause the disk to become the target of a mirror copy. Read all instructions in this section before continuing. This command is used to: • Correct problems with the data in the partition on a mirrored disk • Reset a partition on an improperly created replacement disk If a disk's state is offline for no apparent reason, and it is not the target of a mirror set copy, check the event log for messages indicating invalid data on the partition. If you find any such messages, you can use this command to take corrective action. However, using this command may cause the disk to become the target of a mirror set copy. Use this command to recover from failures resulting from invalid data on the partition. After you successfully reset the partition, the disk may become the target of a mirror set copy. This command only operates on a properly partitioned drive. That is, only errors resulting from invalid data in the partition are corrected. Errors resulting from improper partitioning are not corrected. To correct such problems, use the Disk Administrator to repartition and reformat the disk. (Repartitioning and reformatting results in unrecoverable data loss on the disk to be reformatted.) After you repartition and reformat the disk and reboot the IOP, the disk becomes the target of a mirror set copy. For instructions about how to replace a disk, refer to Replacing a Failed Mirrored Disk on page 236. Command IOPn.Diskx Reset HP NetServer AA Partition Console Syntax MTCCONS IOPn.Diskx Reset HP NetServer AA Partition Variables n - the ID number of the IOP (1 or 2) x - the ID number of the SCSI disk 108