HP NetServer LH 3/LH HP Netserver Ultra3 SCSI HBA Guide - Page 21
Configuration with SCSI
View all HP NetServer LH 3/LH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
2 Configuration with SCSISelect SCSISelect, included with the HP Ultra3 SCSI Host Bus Adapter, enables you to change SCSI settings without opening the computer or handling the host bus adapter. SCSISelect also enables you to low-level format or verify the disk media of your SCSI hard disk drives. The following table lists the available and default settings for each SCSISelect option. NOTE The default settings are appropriate for most systems. Run SCSISelect if you need to change or view current settings, or if you would like to run the SCSI disk utilities. See the descriptions of each option starting on page 17. SCSISelect Options SCSI Bus Interface Definitions: Host Adapter SCSI ID SCSI Parity Checking Host Adapter SCSI Termination LVD/SE Connectors SE Connectors Boot Device Options: Boot SCSI ID Boot LUN Number1 SCSI Device Configuration: Sync Transfer Rate (MBytes/sec) Available Settings Default Setting 0-15 7 Enabled, Disabled Enabled Automatic, Enabled, Automatic Disabled Automatic Automatic Low ON/High ON Low OFF/High OFF Low OFF/High ON 0-15 0 0-7 0 160, 80.0, 53.4, 40.0, 160 32.0, 26.8, 20.0, 16.0, 13.4, 10.0, ASYN 15