HP NetServer LXr 8500 HP Netserver E 60, LC 3, LH 3/3r, and LPr Processor Upgr - Page 10
View the Readme File
View all HP NetServer LXr 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Chapter 2 Preparation 2. Compare the version number on the status report with the version number on the HP NetServer Navigator CD-ROM, as shown in Figure 2-1. tor Version Number HP NetServer Naviga XXXX Figure 2-1. CD-ROM Version Number 3. If you do not have the latest version, obtain it as instructed by the ordering information on the status report. View the Readme File The Readme file on the HP NetServer Navigator CD-ROM contains the most recent information that may not have been available at the time this guide was printed. It is important to check this file before proceeding with the installation. View the Readme file, as follows: 1. Turn on the display monitor and the HP NetServer, and insert the HP NetServer Navigator CD-ROM into the drive. Turn the power off, wait 10 seconds, and turn the power on again. If HP NetServer Navigator fails to start, follow the instructions on the screen. 2. When HP NetServer Navigator starts, you may need to set the language and the time and date. Follow the instructions on the screen. You can also change the language of the BIOS when prompted. When the HP NetServer Navigator starts, you may see an error message that the version of BIOS on the NetServer Navigator CD-ROM is newer than the BIOS detected in your NetServer. ◊ If this message does not appear, your BIOS contains the proper BIOS for the processors installed, and it does not need updating for this purpose. 6