HP NetServer LXr 8500 HP Netserver E 60, LC 3, LH 3/3r, and LPr Processor Upgr - Page 36
Setting System Switches
View all HP NetServer LXr 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Chapter 3 Installation in LC 3 and LH 3/3r Setting System Switches For processor upgrades to a clock speed greater than 450 MHz, examine the table next to the system switches in the upper right corner of the system board, as shown in Figure 3-16. If 500 MHz is not listed in the table, attach the label with system switch settings to the system board. To do so, peel the backing off the label to expose the adhesive, and affix the label to the system board on the table of system switch settings. System Switches Table of System Switch Settings Figure 3-16. Setting System Switches for HP NetServer LC 3 AND LH 3/3r To set the system switches: 1. Locate the system switches at the upper right corner of the system board, as shown in Figure 3-16. 2. Set the switches according to the clock speed (frequency) of your processors, as shown in the table or label next to the system switches. (The system bus frequency is 100 MHz.) 32