HP NetServer LXr 8500 HP Netserver E 60, LC 3, LH 3/3r, and LPr Processor Upgr - Page 23
Removing a Processor Module Without a Processor Retaining Latch, CAUTION
View all HP NetServer LXr 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Chapter 3 Installation in LC 3 and LH 3/3r Removing a Processor Module Without a Processor Retaining Latch To remove a processor module that does not have a processor retaining latch: 1. Press in on each processor module release latch until it remains in (see Figure 3-5). If the latch does not stay in, you must hold it in while removing the module. Processor Eject Lever Processor Mounting Bracket Processor Module Release Latch (Two Places) Figure 3-5. Removing a Processor Module Without a Processor Retaining Latch 2. Lift up on the processor ejector lever until the processor pops out of the processor slot (see Figure 3-5). CAUTION Do not move the processor ejector lever beyond its limit (about 25-30 degree angle from the original position). The ejector lever may break if forced. 19