HP P2000 HP P2000 G3 MSA System Event Description Reference Guide - Page 40

454 Info. A user changed the drive-spin-down delay for the indicated vdisk to the indicated value. Recommended actions • No action required. 455 Warning The controller detected that the configured host-port link speed exceeded the capability of an FC SFP. The speed has been automatically reduced to the maximum value supported by all hardware components in the data path. Recommended actions • Replace the SFP in the indicated port with an SFP that supports a higher speed. 456 Warning The system's IQN was generated from the default OUI because the controllers could not read the OUI from mid-plane FRU ID data during startup. If the IQN is wrong for the system's branding, iSCSI hosts might be unable to access the system. Recommended actions • If a disk discovery timeout - as indicated by event 270 with status code 0 - caused the problem to occur, restart the controllers. 464 Warning A user inserted an unsupported cable or SFP into the indicated controller host port. Recommended actions • Replace the cable or SFP with a supported type, as specified in your product's user guide. 465 Info. A user removed an unsupported cable or SFP from the indicated controller host port. Recommended actions • No action required. 468 Info. FPGA temperature has returned to the normal operating range and the speed of buses connecting the FPGA to downstream adapters has been restored. The speed was reduced to compensate for an FPGA over-temperature condition. Recommended actions • No action required. 469 Info. The speed of buses connecting the FPGA to downstream adapters has been reduced to compensate for an FPGA over-temperature condition. Recommended actions • No action required. 471 Info. A replication was queued because the indicated secondary volume is detached from the replication set. Recommended actions • No action required. • To enable the replication to proceed, reattach the secondary volume and then resume the replication. 40