HP P6000 HP P6300/P6500 EVA iSCSI or iSCSI/FCoE Controller Enclosure Replaceme - Page 1
HP P6000 Manual
View all HP P6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
HP P6300/P6500 EVA iSCSI or iSCSI/FCoE Controller Replacement Instructions About this document For the latest documentation, go to http://www.hp.com/support/ manuals, and select your product. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. WARRANTY STATEMENT: To obtain a copy of the warranty for this product, see the warranty information website: http://www.hp.com/go/storagewarranty © Copyright 2011 Hewlett-Packard Development Company, L.P. First edition: May 2011 The information in this document is subject to change without notice. Printed in Puerto Rico www.hp.com *593089-001* Choosing a storage configuration The following list describes configuration details for the P6300 EVA: • Two HSV340 controllers per controller enclosure • Four SAS ports • Four 1 GbE iSCSI or two 10 GbE iSCSI/FCoE connectors per con- troller • 1/10 (minimum/maximum) disk enclosures • 8/120 (minimum/maximum) M6612 (LFF) disk drives • 8/250 (minimum/maximum) M6625 (SFF) disk drives The following list describes configuration details for the P6500 EVA: • Two HSV360 controllers per controller enclosure • Eight SAS ports • Four 1 GbE iSCSI or two 10 GbE iSCSI/FCoE connectors per con- troller • 2/20 (minimum/maximum) disk enclosures • 8/240 (minimum/maximum) M6612 (LFF) disk drives • 8/450 (minimum/maximum) M6625 (SFF) disk drives Before you begin Observe the following precautions when replacing a controller. CAUTION: HP recommends that you perform the replacement procedure within seven minutes from when the controller is removed to when it is replaced in the enclosure. Ensure all necessary parts are available so the procedure can be completed without interruption. Removing a controller module significantly changes the air flow within the enclosure. Both controllers must be installed for the enclosure to cool properly. If a controller fails, leave it in place in the enclosure until a new module is available to install. The enclosure could shut down due to overheating unless the controller is replaced within the recommended seven minutes. Parts can be damaged by electrostatic discharge. Use proper anti-static protection. Refer to the documentation that shipped with your system for additional information. Page 1