HP Pavilion 11-n200 Maintenance and Service Guide - Page 68
Power button board cable, Display cable
![]() |
View all HP Pavilion 11-n200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
NOTE: When replacing the system board, be sure that the following components are removed from the defective system board and installed on the replacement system board: ● WLAN module (see WLAN module on page 30) ● WWAN module (see WWAN module on page 32) ● Memory module (see Memory module on page 40) ● Solid-state drive (see Solid-state drive (M.2) on page 34) ● Heat sink (see Heat sink on page 46) ● Fan (see Fan on page 44) Remove the system board: 1. Disconnect the following cables from the system board: (1): Power connector cable (2): Wireless antennas (may include one or two antennas) (3): Keyboard cable (4): Webcam cable (5): Display cable (6): Power button board cable (7): Fan cable (8): Speaker cable (9): Touchpad board cable (10): Hard drive cable 2. Remove the four Phillips PM2.0×3.0 screws (1) that secure the system board to the computer. 60 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
![](/manual_guide/products/hewlettpackard-pavilion-11n200-maintenance-service-guide-9cd9a56/68.png)