HP Pavilion 14-bk100 Maintenance and Service Guide - Page 59

Lift the display to bend the hinges upward, then lifting the bracket

Get HP Pavilion 14-bk100 PDF manuals and user guides View all HP Pavilion 14-bk100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 59 highlights

To remove the display assembly: 1. Disconnect the large display panel cable from the system board (1). 2. Disconnect the small display panel cable from the system board (2). 3. Disconnect the wireless antennas from the WLAN module (3). 4. Remove the antenna cables from their routing path in the computer (4). 5. Remove the lock bracket from atop the right hinge by removing the Phillips PM2.5×6.0 screw (1) and then lifting the bracket off the hinge (2). 6. Remove the three Phillips PM2.5×6.0 screws (1) that secure the display assembly to the computer. 7. Lift the display to bend the hinges upward (2). Component replacement procedures 51

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
To remove the display assembly:
1.
Disconnect the large display panel cable from the system board
(1)
.
2.
Disconnect the small display panel cable from the system board
(2)
.
3.
Disconnect the wireless antennas from the WLAN module
(3)
.
4.
Remove the antenna cables from their routing path in the computer
(4)
.
5.
Remove the lock bracket from atop the right hinge by removing the Phillips PM2.5×6.0 screw
(1)
and
then lifting the bracket
off
the hinge
(2)
.
6.
Remove the three Phillips PM2.5×6.0 screws
(1)
that secure the display assembly to the computer.
7.
Lift the display to bend the hinges upward
(2)
.
Component replacement procedures
51