HP Pavilion Notebook - 14-v124ca HP Pavilion 14 Notebook PC HP Pavilion 14 Tou - Page 46

Display subcomponents (bezel, webcamera, panel), and the two Phillips M2.5×3.0 screws

Get HP Pavilion Notebook - 14-v124ca PDF manuals and user guides View all HP Pavilion Notebook - 14-v124ca manuals
Add to My Manuals
Save this manual to your list of manuals

Page 46 highlights

Display subcomponents (bezel, webcamera, panel) This section describes removing display subcomponents that do not require that you remove the entire display assembly from the computer. You can remove the display bezel, webcam/microphone module, and display panel while the display assembly is still attached to the computer. To remove the remaining display subcomponents, you must remove the entire display assembly from the computer. See Display assembly on page 60 for more information about removing the display assembly in its entirety. Description Display bezel (includes screws) Raw display panel, 14 in (35.56 cm), WLED, HD, BrightView flat display panel Raw display panel, 14.0 in (35.56 cm), high definition (HD), WLED, SVA BrightView TouchSmart flat display panel Webcamera/microphone module Webcamera/microphone module, TouchSmart Spare part number 767243-001 763566-001 763567-001 762521-001 762545-001 IMPORTANT: Make special note of each screw and screw lock size and location during removal and replacement Before removing the display panel, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the battery (see Battery on page 30). Remove the panel: If it is necessary to replace the display bezel: 1. Remove the plastic screw covers (1) and the two Phillips M2.5×3.0 screws (2) that secure the display bezel to the display assembly. 2. If it is necessary to replace the display bezel or any of the display assembly subcomponents: a. Flex the inside edges of the top edge (3), the left and right sides (4), and the bottom edge (5) of the display bezel until the bezel disengages from the display enclosure. 36 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
Display subcomponents (bezel, webcamera, panel)
This section describes removing display subcomponents that do not require that you remove the
entire display assembly from the computer. You can remove the display bezel, webcam/microphone
module, and display panel while the display assembly is still attached to the computer.
To remove the remaining display subcomponents, you must remove the entire display assembly from
the computer. See
Display assembly
on page
60
for more information about removing the display
assembly in its entirety.
Description
Spare part number
Display bezel (includes screws)
767243-001
Raw display panel,
14 in
(35.56 cm), WLED, HD, BrightView flat display panel
763566-001
Raw display panel,
14.0 in
(35.56 cm), high definition (HD), WLED, SVA BrightView TouchSmart
flat display panel
763567-001
Webcamera/microphone module
762521-001
Webcamera/microphone module, TouchSmart
762545-001
IMPORTANT:
Make special note of each screw and screw lock size and location during removal
and replacement
Before removing the display panel, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
Battery
on page
30
).
Remove the panel:
If it is necessary to replace the display bezel:
1.
Remove the plastic screw covers
(1)
and the two Phillips M2.5×3.0 screws
(2)
that secure
the display bezel to the display assembly.
2.
If it is necessary to replace the display bezel or any of the display assembly subcomponents:
a.
Flex the inside edges of the top edge
(3)
, the left and right sides
(4)
, and the bottom edge
(5)
of the display bezel until the bezel disengages from the display enclosure.
36
Chapter 6
Removal and replacement procedures for Authorized Service Provider parts