HP Pavilion TouchSmart 15-b100 HP Pavilion TouchSmart Sleekbook 15 and HP Pavi - Page 55
Remove the two Phillips screws, cable bracket
View all HP Pavilion TouchSmart 15-b100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
NOTE: The heat sink on your system board may appear different from the heat sink shown. 1. Disconnect the following cables from the system board: (1) Display panel cable (2) Speaker cable (3) Fan power connector cable 2. Remove the power connector cable bracket Phillips screw (1) and remove the power connector cable bracket (2). 3. Remove the two Phillips screws (3) that secure the system board to the base enclosure. 4. Lift the left side of the system board (1) until it rests at an angle. Component replacement procedures 47
NOTE:
The heat sink on your system board may appear different from the heat sink shown.
1.
Disconnect the following cables from the system board:
(1)
Display panel cable
(2)
Speaker cable
(3)
Fan power connector cable
2.
Remove the power connector cable bracket Phillips screw
(1)
and remove the power connector
cable bracket
(2)
.
3.
Remove the two Phillips screws
(3)
that secure the system board to the base enclosure.
4.
Lift the left side of the system board
(1)
until it rests at an angle.
Component replacement procedures
47