HP Photosmart 2700 Setup Guide - Page 16
Q3452-90203
![]() |
View all HP Photosmart 2700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Troubleshooting *Q3452-90203* *Q3452-90203* Q3452-90203 Problem: The Remove and check print cartridges message appears after you insert print cartridges. Action: Remove print cartridges. Make sure you remove all tape from copper contacts. Close the access door. Problem: The paper has jammed. Action: Remove the back access door and gently pull out any paper. Turn the device off, and then on. Load the paper again. Problem: You did not see the screen prompting you to connect the USB cable. Action: Remove, and then re-insert the HP all-in-one Windows CD. Refer to Section A. Problem: The Microsoft Add Hardware screen appears. Action: Click Cancel. Unplug the USB cable, and then insert the HP all-in-one Windows CD. Refer to Section A. Problem: The Device Setup Has Failed To Complete screen appears. Action: Verify that the control-panel overlay is firmly attached. Unplug the HP all-in-one and plug it in again. Check all connections. Make sure the USB cable is plugged into the computer. Do not plug the USB cable into a keyboard or nonpowered hub. Refer to Section A. Problem: The Macintosh software does not install. Action: Make sure the USB cable is plugged into the computer before installing the software. Do not plug the USB cable into a keyboard or non-powered hub. Refer to Section A. For network software problems, see the Network Guide. Refer to the User Guide for more information. Printed on recycled paper. Visit www.hp.com/support for assistance. © Copyright 2004 Hewlett-Packard Development Company, L.P. Printed in country []. Printed in country [].
![](/manual_guide/products/hewlettpackard-photosmart-2700-setup-guide-17a6f12/16.png)