HP Pro 1000 HP Pro 1005 All-in-One Business PC - Maintenance & Service - Page 123
Table B-1, Control panel message, Description, Recommended action
View all HP Pro 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
Table B-1 Numeric Codes and Text Messages (continued) Control panel message Description Recommended action 1805-Ambient Temperature Previously Over This system was placed in a low power Limit state to prevent damage due to excessive environmental temperature. Make sure the system meets the HP enclosure guidelines as listed in the QuickSpecs, including the following: 1. Clean the air vents on the front, back, or any other vented side of the computer. 2. Ensure that there is a 10.2 cm (4 in) clearance on all vented sides of the computer to permit the required airflow. 3. Ensure that computers are not so near each other that they are subject to each other's re-circulated or preheated air. 4. If the computer is within an enclosure, ensure that there is proper intake and exhaust ventilation for the enclosure. 2200-PMM Allocation Error during MEBx Download Memory error during POST execution of the 1. Management Engine (ME) BIOS Extensions option ROM. 2. Reboot the computer. Unplug the power cord, re-seat the memory modules, and reboot the computer. 3. If the memory configuration was recently changed, unplug the computer, restore the original memory configuration, and reboot the computer. 4. If the error persists, replace the system board. 2201-MEBx Module did not checksum correctly Memory error during POST execution of the 1. Management Engine (ME) BIOS Extensions option ROM. 2. Reboot the computer. Unplug the power cord, re-seat the memory modules, and reboot the computer. 3. If the memory configuration was recently changed, unplug the power cord, restore the original memory configuration, and reboot the computer. 4. If the error persists, replace the system board. POST Numeric Codes and Text Messages 115