HP Pro 3335 Micro Maintenance & Service Guide Pro 3330/3380 Microtower Pro - Page 127
Removing Drives, Removing an Optical Drive
View all HP Pro 3335 Micro manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
To verify the type and size of the storage devices installed in the computer, run Computer Setup. Removing Drives When installing drives, follow these guidelines: ● The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA connector on the system board labeled SATA0. ● Connect an optical drive to the light blue SATA connector on the system board labeled SATA2. ● Connect a media card reader to the system board connector labeled F_USB1. ● The power cables for the SATA drives connect directly to the power supply. The primary hard drive connects to the power connector labeled P4. the primary optical drive connects to the power connector labeled P3. ● The system does not support Parallel ATA (PATA) optical drives or PATA hard drives. CAUTION: To prevent loss of work and damage to the computer or drive: If you are inserting or removing a drive, shut down the operating system properly, turn off the computer, and unplug the power cord. Do not remove a drive while the computer is on or in standby mode. Before handling a drive, ensure that you are discharged of static electricity. While handling a drive, avoid touching the connector. For more information about preventing electrostatic damage, refer to Electrostatic Discharge Information on page 41. Handle a drive carefully; do not drop it. Do not use excessive force when inserting a drive. Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields such as monitors or speakers. If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and label the package "Fragile: Handle With Care." Removing an Optical Drive CAUTION: All removable media should be taken out of a drive before removing the drive from the computer. 1. Prepare the computer for disassembly (Preparation for Disassembly on page 101). 2. Remove the access panel (Access Panel on page 102). 3. Remove the front bezel (Front Bezel on page 104). 4. Rotate the drive cage to its upright position. Drives 117