HP ProSignia 500 Compaq ProSignia Family of PC Servers Maintenance and Service - Page 25
Not Been Detected By, Secondary Disk Port
![]() |
View all HP ProSignia 500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
612-Secondary Floppy Configuration error. Run the EISA Port Address Assignment Configuration Utility Conflict and correct. 702-A coprocessor has Installed coprocessor Run the EISA been detected that was not configured. Configuration Utility not reported by CMOS. and correct. 703-CMOS Reports A Coprocessor or 1. Run the EISA Coprocessor That Has configuration error. Configuration Not Been Detected By Utility and correct. POST 2. Replace the coprocessor. 1151-COM Port 1 Both external and Run the EISA internal serial ports Configuration Utility are assigned to COM1. and correct. 1152-COM Port 2 Both external and Run the EISA internal serial ports Configuration Utility are assigned to COM2. and correct. Error Code Probable Source Action of Problem 1153-COM Port 3 Both external and Run the EISA internal serial ports Configuration Utility are assigned to COM3. and correct. 1154-COM Port 4 Both external and Run the EISA internal serial ports Configuration Utility are assigned to COM4. and correct. 1701-SCSI Controller A test on the Run Diagnostics. Failure Controller failed. Replace failed assembly as indicated or, contact your service provider. 1771-Primary Disk Port Internal and external Run the EISA Address Assignment hard drive controllers Configuration Utility Conflict are both assigned to and correct. the primary address. 1772-Secondary Disk Port Address Assignment Run the EISA Conflict. Internal Configuration Utility and external hard and correct. drive controllers are both assigned to the secondary address. 1777-Slot # Drive Array Configuration error. Run the EISA Controller has been Configuration Utility upgraded. Run System and correct. Configuration Utility 1778-Slot # Drive Array This message appears No action necessary. resuming Automatic Data whenever a controller Recovery process reset or power cycle occurs while Automatic
![](/manual_guide/products/hewlettpackard-prosignia-500-compaq-prosignia-family-pc-servers-maintenance-service-guide-2036ea6/25.png)