HP SW TL881 DLT Mini-Lib/1 Compaq StorageWorks TL881/TL891 Family MiniLibrary - Page 13

Replacing, Removing and Replacing the Cover Plate, Removing

Get HP SW TL881 DLT Mini-Lib/1 PDF manuals and user guides View all HP SW TL881 DLT Mini-Lib/1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

Adding a Second Drive 5 Replacing To replace the skin cover on the Base Module: 1. Slide the skin cover over the module until it touches the front panel. 2. Insert the four screws (2 each side) through the skin cover into the Base Module. Do not tighten the screws yet. 3. Position the front edge of the skin cover so that it is flush against the back of the front panel. 4. Tighten the four screws (2 each side) into the Base Module. Removing and Replacing the Cover Plate Removing To remove the cover plate from the Base Module: 1. If the Base Module is a desktop model, remove the skin cover as described in "Removing and Replacing the Skin Cover (Desktop Models Only)." 2. Disconnect the power and interface cables at the rear of the module. 3. Unscrew the captive screw in the center of the cover plate (Figure 3). 4. Slide the cover plate one-half inch toward the rear of the module. 5. Lift the cover plate off the Base Module.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
Adding a Second Drive
5
Replacing
To replace the skin cover on the Base Module:
1.
Slide the skin cover over the module until it touches the front panel.
2.
Insert the four screws (2 each side) through the skin cover into the Base
Module. Do not tighten the screws yet.
3.
Position the front edge of the skin cover so that it is flush against the
back of the front panel.
4.
Tighten the four screws (2 each side) into the Base Module.
Removing and Replacing the Cover Plate
Removing
To remove the cover plate from the Base Module:
1.
If the Base Module is a desktop model, remove the skin cover as
described in “Removing and Replacing the Skin Cover (Desktop Models
Only).”
2.
Disconnect the power and interface cables at the rear of the module.
3.
Unscrew the captive screw in the center of the cover plate (Figure 3).
4.
Slide the cover plate one-half inch toward the rear of the module.
5.
Lift the cover plate off the Base Module.