HP SW TL881 DLT Mini-Lib/1 Compaq StorageWorks TL881/TL891 Family MiniLibrary - Page 14

Replacing, Removing and Replacing the Drive Caddy Assembly

Get HP SW TL881 DLT Mini-Lib/1 PDF manuals and user guides View all HP SW TL881 DLT Mini-Lib/1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

6 Compaq StorageWorks TL881/TL891 Family MiniLibrary System Drive Upgrade Procedure Replacing To replace the cover plate on the Base Module: 1. Place the cover plate on the Base Module so that it overhangs one-half inch at the rear of the module (Figure 3). 2. Slide the cover plate toward the front of the Base Module until the cover plate touches the front panel. 3. Tighten the captive screw in the center of the cover plate. 4. Connect the power and interface cables at the rear of the module. 5. If the Base Module is a desktop model, replace the skin cover as described in "Removing and Replacing the Skin Cover (Desktop Models Only)." Figure 3. Removing the cover plate SHR-1721 Removing and Replacing the Drive Caddy Assembly The drive caddy assembly is an enclosure that holds one or two DLT drives and the interconnecting cables. The assembly includes the SCSI interface connectors and cables for the Base Module, the power cables for the drives, and communication cables from the drives to the controller PWB.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
6
Compaq StorageWorks TL881/TL891 Family MiniLibrary System Drive Upgrade Procedure
Replacing
To replace the cover plate on the Base Module:
1.
Place the cover plate on the Base Module so that it overhangs one-half
inch at the rear of the module (Figure 3).
2.
Slide the cover plate toward the front of the Base Module until the cover
plate touches the front panel.
3.
Tighten the captive screw in the center of the cover plate.
4.
Connect the power and interface cables at the rear of the module.
5.
If the Base Module is a desktop model, replace the skin cover as
described in “Removing and Replacing the Skin Cover (Desktop Models
Only).”
Figure 3.
Removing the cover plate
Removing and Replacing the Drive Caddy Assembly
The drive caddy assembly is an enclosure that holds one or two DLT drives
and the interconnecting cables. The assembly includes the SCSI interface
connectors and cables for the Base Module, the power cables for the drives,
and communication cables from the drives to the controller PWB.
SHR-1721