HP Scitex FB10000 Geffen TS Error 67009 - Page 7

If the MXCHG LED continues blinking orange single pulse every 5 seconds, please consult the detailed

Page 7 highlights

Error ID: 67009: Safety - Bridge front door is open. Troubleshooting 9. If the MXCHG LED continues blinking orange single pulse every 5 seconds, this indicates that the PLC failed to configure the new module (in case of 2 replaced modules, it will blink twice every 5 seconds etc.). Check if you have set the scan selector according to the number of new modules. Note: Interchanging two existing modules will be detected by the Safety PLC as two new modules. 10. If the MXCHG LED continues blinking orange single pulse every 5 seconds, please consult the detailed B&R PLC configuration guide, on page 4 for further instructions. 11. If none of the above steps solved the problem, contact your HP service specialist. Note: The diagram in the page below shows the tested components and provides a legend of the B&R naming conventions. Top Flowchart 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

Error ID: 67009: Safety - Bridge front door is open.
Troubleshooting
9.
If the MXCHG LED continues blinking orange single pulse every 5 seconds, this indicates that the PLC failed to configure the new module
(in case of 2 replaced modules, it will blink twice every 5 seconds etc.). Check if you have set the scan selector according to the number of
new modules.
Note: Interchanging two existing modules will be detected by the Safety PLC as two new modules.
10.
If the MXCHG LED continues blinking orange single pulse every 5 seconds, please consult the detailed B&R PLC configuration guide, on
page 4 for further instructions.
11.
If none of the above steps solved the problem, contact your HP service specialist.
Note: The diagram in the page below shows the tested components and provides a legend of the B&R naming conventions.
Top
Flowchart
7