HP Scitex FB700 HP Scitex FB500 and FB700 Printer Series - User Cleaning Instr - Page 27

Replace the service station wiper (quarterly), Proceed

Get HP Scitex FB700 PDF manuals and user guides View all HP Scitex FB700 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

4. Vacuum the filter (A in photo below.) located under the printer's chassis near the power cord attachment point, and remove dust from the surrounding area. Figure 24 Cleaning dust from the electronics box fan filter 5. To reset the maintenance counter for this task and complete the procedure, press Proceed. Replace the service station wiper (quarterly) The wiper blade deteriorates with use. Replacing the wiper blade periodically restores the wiping to optimal performance and wiper height. NOTE: Replace the wiper according to the schedule in Table 1 Schedule of cleaning tasks on page 1. The wiper replacement schedule is calculated to be frequent enough to avoid the need for wiper-height calibrations between replacements. If the wipers are not making adequate contact with the printheads, contact your service provider to calibrate the wiper height. 1. From the control panel (System page > Tools > User Cleaning and Maintenance), select Replace Service Station Wiper. 2. Press Proceed to continue. 3. Open the service door to access the service station. 4. Move the printhead carriage away from the service station. ENWW Replace the service station wiper (quarterly) 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
4.
Vacuum the filter (A in photo below.) located under the printer's chassis near the power cord
attachment point, and remove dust from the surrounding area.
Figure 24
Cleaning dust from the electronics box fan filter
5.
To reset the maintenance counter for this task and complete the procedure, press
Proceed
.
Replace the service station wiper (quarterly)
The wiper blade deteriorates with use. Replacing the wiper blade periodically restores the wiping to
optimal performance and wiper height.
NOTE:
Replace the wiper according to the schedule in
Table
1
Schedule of cleaning tasks
on page
1
. The wiper replacement schedule is calculated to be frequent enough to avoid the need for
wiper-height calibrations between replacements. If the wipers are not making adequate contact with
the printheads, contact your service provider to calibrate the wiper height.
1.
From the control panel (
System page > Tools > User Cleaning and Maintenance
), select
Replace Service Station Wiper
.
2.
Press
Proceed
to continue.
3.
Open the service door to access the service station.
4.
Move the printhead carriage away from the service station.
ENWW
Replace the service station wiper (quarterly)
25