HP Spectre 12-a000 Maintenance and Service Guide - Page 40
Card reader board, to which the card reader board cable is attached, and then disconnect
View all HP Spectre 12-a000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Card reader board NOTE: The card reader board spare part kit does not include the card reader board cable. The card reader board cable is available using spare part number 830334-001. Description Card reader board (includes memory card reader slot and power button actuator): For use only on slate models with WLAN and WWAN capability (includes SIM slot) For use only on slate models with only WLAN capability Spare part number 830343-001 830342-001 Before removing the card reader board, follow these steps: 1. Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then shut it down through the operating system. 2. Disconnect the power from the slate by unplugging the power cord from the slate. 3. Disconnect all external devices from the slate. 4. Remove the display panel assembly (see Display panel assembly on page 20). Remove the card reader board: 1. Release the ZIF connector (1) to which the card reader board cable is attached, and then disconnect the card reader board cable from the system board. 2. Remove the Phillips PM2.0×2.2 broad head screw (2) that secures the card reader board to the bottom cover. 3. Remove the card reader board (3). Reverse this procedure to install the card reader board. 30 Chapter 5 Removal and replacement procedures