HP StorageWorks 4/64 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 486
SULB-1018, Probable Cause, firmwareDownload, Recommended, Action, slotShow, slotPowerOff, Severity
View all HP StorageWorks 4/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 486 highlights
69 SULB-1018 Probable Cause Indicates that firmwareDownload failed in the specified blade. The error may be caused by an inconsistent AP blade firmware stored on the active CP. It may also caused by an internal Ethernet issue or by a persistent storage hardware failure. Recommended Action Run the slotShow command. If the blade is in a FAULTY state, run the slotPowerOff and slotPowerOn commands to trigger another firmwareDownload. If the blade is stuck in LOADING state, remove and re-insert the blade to trigger another firmwareDownload. If the problem persists, contact your switch service provider. Severity ERROR SULB-1018 Message , [SULB-1018], , AUDIT, ERROR, , Firmwaredownload timed out in slot . Probable Cause The error may be caused by a blade initialization issue after the new firmware is downloaded and the blade is rebooted. The error may also be caused by an internal Ethernet issue or by a persistent storage failure. Recommended Action Run the slotShow command. If the blade is in FAULTY state, run the slotPowerOff and slotPowerOn commands to trigger another firmwareDownload. If the blade is stuck in LOADING state, remove and re-insert the blade to trigger another firmwareDownload. If the problem persists, contact your switch service provider. Severity ERROR SULB-1020 Message , [SULB-1020], AUDIT, ERROR, , New firmware failed to boot in slot . Probable Cause The BP blade should reboot with the new image, but is still running the old image. This error may indicate that the new image has not been loaded correctly to the specified blade. Recommended Action Run the slotShow command. If the blade is in a FAULTY state, run the slotPowerOff and slotPowerOn commands to trigger another firmwareDownload to the blade. If the blade is stuck in LOADING state, remove and re-insert the blade to trigger another firmwareDownload. If the problem persists, contact your switch service provider. Severity ERROR SULB-1021 Message Probable Cause , [SULB-1021],, AUDIT, WARNING, , Firmware is being downloaded to the blade in slot . Indicates that the firmware is being loaded to the indicated blade. 434 Fabric OS Message Reference 53-1000600-02