HP StorageWorks 4/64 Brocade Fabric OS Command Reference Manual v6.2.0 (53-100 - Page 606
portCfgShow, Synopsis, Description, Speed, portCfgSpeed, AL_PA Offset 13, portCfgAlpa, Trunk Port
View all HP StorageWorks 4/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 606 highlights
2 portCfgShow portCfgShow Displays port configuration settings. Synopsis portcfgshow portcfgshow [[slot/]port] portcfgshow option [slot/][ge]port [arguments] [optional arguments] Description Use this command to display the current configuration of a port. If no operand is specified, this command displays port configuration settings for all ports on a switch, except gigabit Ethernet (GbE) ports. Additionally, use this command with optional arguments to display specific FCIP parameters configured for a gigabit Ethernet port, such as the following: • Address resolution protocol (ARP) entries • IP interfaces on the GbE port • Static routes on the IP interfaces • Fibre Channel over IP (FCIP) tunnel configuration settings - IKE and IPSec policy information - QoS mappings • Port Mode information • VLAN tag configuration • Inband Management IP addresses and routes configured on the Brocade 7500 The following information is displayed when the command is issued for all ports or for a specific port: Speed Displays AN for auto speed negotiation mode, or a specific speed of 1, 2, 4, or 8 Gbps. This value is set by the portCfgSpeed command. AL_PA Offset 13 Displays (...) or OFF when the arbitrated loop physical address (AL_PA) on the port is configured to use a 0x0 AL_PA address (default). Displays ON when the address configuration is 0x13 AL_PA. This value is set by the portCfgAlpa command. Trunk Port Displays ON when port is set for trunking. Displays (..) or OFF when trunking is disabled on the port. This value is set by the portCfgTrunkPort command. Long Distance Displays (..) or OFF when long distance mode is off; otherwise, displays long distance levels as follows: LE The link is up to 10 km. LM The link is up to 25 km. L1 The link is up to 50 km. L2 The link is up to 100 km. LD The distance is determined dynamically. LS The distance is determined statically by user input. This value is set by the portCfgLongDistance command. 578 Fabric OS Command Reference 53-1001186-01