HP StorageWorks 8/20q HP StorageWorks 8/20q Fibre Channel Switch event message - Page 28

Table 4 Alarm events and recommended action (Continued) Icon Event ID and message Description Action (A1005.0070) (Hotreset to older firmware version not supported. A reset is required to activate this version of firmware) (A1005.0071) (Unable to obtain dynamic IP address, falling back to static IP address of address on interface interface) (A1005.0072) (Unable to turn off lasers, please power off the switch) The installed firmware cannot Perform a hard reset. be activated without disrupting I/O traffic. The switch was unable to obtain its IP address from the Dynamic Host Configuration Protocol (DHCP) server. The static IP address will be used. Investigate the DHCP server. Conditions exist that could damage the switch and the switch was unable to turn off the Fibre Channel (FC) port lasers. Power down the switch and contact your authorized maintenance provider. (A1006.0004) (Zoning conflict, device_WWN is in an ACL hard zone, but device_WWN share a soft zone) The named zone members cannot communicate because they are members of different hard zones. Place both zone members in the same hard zone or exclude both from hard zones. (A1006.0005) (Zoning enforcement error in Nameserver) An error occurred while checking hard zoning. Contact your authorized maintenance provider. (A1006.0006) (Zoning conflict, device_WWN and device_WWN do not share an ACL hard zone, but device_WWN share a soft zone) The named zone members cannot communicate because they are members of different hard zones. Place both zone members in the same hard zone or exclude both from hard zones. (A1007.0001) (Security: Unspecified zoning enforcement error) A device was not authorized or it failed security checks and will not be allowed to join the fabric. None (A1007.0002) (Security: Remote Switch with WorldWide Name (WWN) wwn configured for chap, no chap configured for local switch. 2-way Authentication Failure) The device worldwide name (WWN) is either not configured in the security database, or it is not configured for Challenge Handshake Authentication Protocol (CHAP). Add the device WWN to the active security set if it missing, or modify the group to allow for CHAP authentication with the other devices. (A1007.0005) (Security: Authentication request was rejected by port.) Indicates that a remote switch rejected a security authentication attempt. The port will isolate. Checks the security configuration on the remote switch to determine the problem. (A1007.0006) (Security: Could not validate Authentication Response from port_number, payload seems to be incorrect.) The format of the payload of the response frame does not match what was expected. Check for errors on the remote side of the link. Check the transceiver and cable. Update firmware on remote switch. 28