HP StorageWorks 8/20q HP StorageWorks 8/20q Fibre Channel Switch event message - Page 32
A Remote Authentication Dial, Datagram Protocol UDP
![]() |
View all HP StorageWorks 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Table 4 Alarm events and recommended action (Continued) Icon Event ID and message Description Action (A1007.0027) (Radius server could not validate authentication response from port_number) (A1007.0028) (Security: 2-Way Authentication, No security entry found for port) (A1007.0029) (Security protocol not using chap, unable to authenticate.) (A1007.002A) (Inconsistent Fabric Binding configuration. Enabled on remote switch(s), disabled on local switch. A Remote Authentication Dial Confirm that the secret is the In User Service (RADIUS) same on the switch as it is on authentication failed. the RADIUS server. Unable to locate a security member entry to complete a two-way authentication. Edit the group to include the port. A Challenge Handshake Authentication Protocol (CHAP) negotiate frame that specifies an unsupported authentication protocol was received. Check the remote device for a possible error condition. Reset the port to try again. If errors continue, disable CHAP for this device if the device belongs in the fabric. Inconsistent fabric binding configuration settings between the local and remote switch. All switches in the fabric must have the same fabric binding setting. Enable or disable fabric binding on all switches. (A1007.002B) (Security: Chap session Negotiate Authentication failed) (A1007.002C) (Security: Authentication protocol msg (AUTH_DONE) inconsistent with Authentication protocol in progress) (A1007.002D) (Ignoring RADIUS Server RADIUS_server, invalid UDP port configured) The local switch received an authentication negotiate frame which failed processing. Either the payload of the frame did not match the standard layout of the frame or the Challenge Handshake Authentication Protocol (CHAP) session between the devices being authenticated was not in the state where the negotiate frame was expected. Check the remote device for a possible error condition. Reset the port to retry again. If errors continue, disable CHAP for this device if it belongs in the fabric. The local switch received an auth_done command authentication frame while the Challenge Handshake Authentication Protocol (CHAP) session was not in the correct state. The remote device is not following standard authentication protocol. Check the remote device for a possible error condition. Reset the port to retry again. If errors continue, disable CHAP for this device if it belongs in the fabric. A Remote Authentication Dial In User Service (RADIUS) server was configured with invalid data for the User Datagram Protocol (UDP) port. This is a required configuration field for the RADIUS server to be used. Set the UDP port value in the switch RADIUS server configuration using the set setup radius command. 32
![](/manual_guide/products/hewlettpackard-ak241a-hp-storageworks-820q-fibre-channel-switch-event-messages-reference-guide-56977200-2008-e16a048/32.png)