HP StorageWorks 8/20q HP StorageWorks 8/20q Fibre Channel Switch event message - Page 22
an E_Port., InteropMode, LegacyAddressFormat
View all HP StorageWorks 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Table 4 Alarm events and recommended action (Continued) Icon Event ID and message Description Action (A1004.0024) (Attempting to connect to switch that is in non-interop mode) An attempt was made to connect to a switch with a different value for interop mode. Modify the interop mode values so that they are the same on both switches. (A1004.0026) (Configured Domain ID domain_ID not available and Domain ID is locked on this switch) An attempt was made to connect a switch to a fabric with a conflicting domain ID, and the domain ID could not be reassigned. Change the domain ID so that it is unique in the fabric, or disable the domain ID lock so that the domain ID can be automatically reassigned. (A1004.0029) (No Switch capable of being Principal Switch. Reconfigure Principal Switch Priority.) (A1004.002B) (Port port_number not configured for E-Port capability, reconfigure to G/GL to connect to remote switch) (A1004.002F) (Request for Domain ID rejected, WorldWide Name (WWN) device_WWN not allowed to join fabric.) (A1004.0030) (Topology change, lost route to switch with domain ID domain_ID) (A1004.0032) (E_Port not supported on remote port. Reconfigure remote switch to connect.) (A1004.0033) (Remote switch is in Interop mode or using Legacy Address Format) (A1004.0034) (Failed to connect to a switch due to incompatibility contact technical support.) An E_Port isolated because the principal priority on all switches is set to 254. Configure one of the switches to be the principal switch by changing the principal priority. An attempt was made by a remote switch to connect through a port that could not configure itself as an E_Port. Change the port type on the remote switch to G_Port or GL_Port. The switch with the specified Add the switch to a group in worldwide name (WWN) is the active security set. not allowed to join the fabric. Connection to a switch in the fabric was lost. Inspect switch connections and device hardware for proper operation. Review accompanying alarms for other causes. An E_Port isolated because the port on the remote switch could not configure itself as an E_Port. Change the port type on the remote switch to G_Port or GL_Port. A remote switch is attempting to connect with conflicting settings for InteropMode or LegacyAddressFormat. Configure the switches so that InteropMode and LegacyAddressFormat settings are the same throughout the fabric. The two switches are incompatible. Possible causes include incompatible configurations, incompatible firmware versions, and incompatible licensing. Verify that configurations, firmware versions, and licensing on the remote switch are compatible. If they are not, contact your authorized maintenance provider. (A1004.0035) (Failed to connect to a switch due to incompatibility check interop settings.) The remote switch failed to connect possibly because the InteropMode setting is different from that of the local switch. Reconcile the InteropMode settings on the local and remote switches so that they are the same. If necessary, contact your authorized maintenance provider. 22