HP StorageWorks 8/20q HP StorageWorks 8/20q Fibre Channel Switch event message - Page 24
specified Fibre Channel FC, but that device was
View all HP StorageWorks 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Table 4 Alarm events and recommended action (Continued) Icon Event ID and message Description Action (A1004.0048) (Eport Isolating due to Port Binding failure) (A1004.0049) (Eport Isolating due to Remote inactive) A switch device attempted to login as an inter-switch link (ISL), but that device was not configured in the port binding list. Add the device to the port binding list. The remote switch is unresponsive, and the link has not been brought up. The port will be isolated because the remote switch failed to respond. Investigate the remote switch for connection problems. (A1004.0050) (Maximum hard zoning member limit exceeded, Reverting to soft zoning. Requires port reset.) (A1004.0052) (Eport Isolating due to Switch Binding failure) (A1004.0053) (Adding Denial of Service entry for source FC Address 0xaddress) The maximum number of zone members associated with a port is limited to 64. If this number is exceeded, the switch cannot enforce hard zoning and will revert to soft zoning. Reduce the number of zone members associated with the port and reset the port. A device attempted to login as an inter-switch link (ISL), but that device was not configured in the switch binding list. Add the device to the switch binding list. A number of frames from the indicated address have been received. These frames are from a source that is not zoned with the destination. A denial of service entry will be set up to discard these frames. Investigate the source at the specified Fibre Channel (FC) address. (A1004.0054) (Eport Isolating due to Link to self) Two ports on the same switch Disconnect one or both ports. cannot be connected to one another. (A1004.0060) (Virtual Lanes configuration change will take effect on next port reset) The virtual lanes configuration does not become active until you reset the port. Reset the port. (A1005.0006) (Request from WWN device_WWN address FC_address, failed authentication, verify MS security configuration) Management server authentication is enabled, and the received frame failed authentication. Verify the MS group configuration. (A1005.000A) (Cannot enforce zoning for member domain_ID, port_number, this zone member will be ignored) A zone member given by domain ID and port number could not be found in the fabric. Examine the fabric connections and zoning definitions. 24