HP StorageWorks 8/40 Brocade Converged Enhanced Ethernet Command Reference v6. - Page 123
Layer 2 System Commands
View all HP StorageWorks 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
Layer 2 System Commands Chapter 7 mac-address-table Use this command to set the aging time or to add static addresses to the MAC address table. Synopsis mac-address-table {aging-time seconds| static mac-addr forward [port-channel number | tengigabitethernet slot/port | vlan vlan_id] } no mac-address-table {aging-time | static mac-addr forward [ port-channel number | tengigabitethernet slot/port | vlan vlan_id] } Operands aging-time seconds Specifies the time in seconds that a learned MAC address will persist after the last update. If the aging time is set to zero (0), it means that aging is disabled. The range of valid values is 10-100000. static mac-addr Specifies the Media Access Control (MAC) address (unicast or multicast) to add to the address table. Packets with this destination address received in the specified VLAN are forwarded to the specified interface. forward Forwards the MAC address to the interface. port-channel number Specifies the port-channel number. The range of valid values is 1-63. tengigabitethernet Specifies a valid 10 Gbps Ethernet interface. slot Specifies a valid slot number. port Specifies a valid port number. vlan vlan_id Specifies the VLAN number. The range of valid values is 1-3583. Defaults The default aging time is 300 seconds. Command Global configuration mode Modes Description Use this command to set the aging time or to add static addresses to the MAC address table. Usage The vlan keyword is mandatory because the switch only supports independent VLAN learning (IVL). Guidelines Examples To add the static address 0011.2222.3333 to the MAC address table with a packet received on VLAN 100: switch(config)#mac-address-table static 0011.2222.3333 forward tengigabitethernet 0/1 vlan 100 Converged Enhanced Ethernet Command Reference 105 53-1001347-01