HP StorageWorks 8/8 Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001 - Page 402
implicitly when running the, explicitly ends the transaction owned by
View all HP StorageWorks 8/8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 402 highlights
2 ipfilter -sip Specifies the source IP address. For filters of type IPv4, the address must be a 32-bit address in dot notation, or a CIDR-style IPv4 prefix. For filters of type IPv6, the address must be a 12- bit IPv6 address in any format specified by RFC, or a CIDR-style IPv6 prefix. -dp -proto Specifies the destination port number, a range of port numbers, or a service name. Specifies the protocol type, for example tcp or udp. -act Specifies the permit or deny action associated with this rule. rule rule_number Adds a new rule at the specified rule index number. The rule number must be between 1 and the current maximum rule number plus one. --delrule policyname -rule rule_number Deletes a rule from the specified IP filter policy. Deleting a rule in the specified IP filter policy causes the rules following the deleted rule to shift up in rule order. The change to the specified IP filter policy is not saved to the persistent configuration until it is saved or activated. --transabort A transaction is associated with a CLI or manageability session. It is opened implicitly when running the --create, --addrule and --delrule subcommands. --transabort explicitly ends the transaction owned by the current CLI or manageability session. If a transaction is not ended, other CLI or manageability sessions are blocked on the subcommands that would open a new transaction. Examples To create an IP filter for a policy with an IPv6 address: switch:admin> ipfilter --create ex1 -type ipv6 To add a new rule to the policy and specify the source IP address, destination port, and protocol, and to permit the rule: switch:admin> ipfilter --addrule ex1 -sip fec0:60:69bc:60:260:69ff:fe80:d4a -dp 23 \ -proto tcp -act permit To display all existing IP filter policies: switch:admin> ipfilter --show Name: default_ipv4, Type: ipv4, State: active Rule Source IP Protocol Dest Port Action 1 any tcp 22 permit 2 any tcp 23 permit 3 any tcp 897 permit 4 any tcp 898 permit 5 any tcp 111 permit 6 any tcp 80 permit 7 any tcp 443 permit 8 any udp 161 permit 9 any udp 111 permit 10 any udp 123 permit 11 any tcp 600 - 1023 permit 12 any udp 600 - 1023 permit Name: default_ipv6, Type: ipv6, State: active 374 Fabric OS Command Reference 53-1001186-01