HP StorageWorks 8/8 Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001 - Page 81
bladeEnable, Synopsis, Description, Notes, chassisEnable, Operands, Examples
View all HP StorageWorks 8/8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
bladeEnable 2 bladeEnable Synopsis Enables all user ports on a blade. bladeenable slotnumber Description Use this command to enable all user ports on a blade. All ports within the blade that did not fail the power-on self-test (POST) are enabled (except for persistently disabled ports). They may come online if connected to a device, or remain offline if disconnected. Use bladeEnable to re-enable the blade after making configuration changes or running offline diagnostics. If the switch is connected to a fabric through previously disabled ports, it rejoins the fabric. If this switch remains the principal switch at the end of the fabric countdown, it assigns itself a domain ID. If another switch assumes the principal role, the re-enabled switch becomes a subordinate switch and accepts a domain ID from the principal. As each port is enabled, the front panel LED changes from slow flashing amber to green for online ports or to yellow for ports that do not initialize. Disconnected ports remain unlit. Notes You cannot disable a single blade when the entire chassis is disabled, or when the blade itself is faulted, powered off, or running diagnostics. Use chassisEnable to enable the ports on an entire chassis. Persistently disabled ports are not enabled by this command. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands This command has the following operand: slotnumber Specifies the slot number to be enabled. Examples To display the slot status, enable the user ports in slot 4, and verify the settings: switch:admin> slotshow Slot Blade Type ID Status 1 SW BLADE 2 ENABLED 2 UNKNOWN VACANT 3 UNKNOWN VACANT 4 SW BLADE 2 ENABLED (User Ports Disabled) 5 CP BLADE 1 ENABLED 6 CP BLADE 1 ENABLED 7 SW BLADE 2 ENABLED 8 UNKNOWN VACANT 9 UNKNOWN VACANT 10 UNKNOWN VACANT switch:admin> bladeenable 4 slBlade 4 is being enabled...Done Fabric OS Command Reference 53 53-1001186-01