HP StorageWorks Disk System 2110 HP StorageWorks Disk System 2100/2110 User's - Page 10

SCSI ID Switch, disk modules are 9

Get HP StorageWorks Disk System 2110 PDF manuals and user guides View all HP StorageWorks Disk System 2110 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

10 HP StorageWorks Disk System 2100 / 2110 SCSI ID Switch The SCSI ID switch sets the address for the disk drives. There are three possible settings for the SCSI address switch: A, B, and C. Each setting assigns a different set of addresses to the disk modules installed in the disk system. For SCSI address switch setting A, the addresses for the installed disk modules are (from left to right, looking at the disk system from the front) 0, 2, 4, and 6. For SCSI address switch setting B, the addresses for the installed disk modules are 8, 10, 12, and 14. For SCSI address switch setting C, the addresses for the installed disk modules are 9, 11, 13, and 15. See Figure 5, below. SCSI address 7 is reserved for use by the host bus adapter. FIGURE 5 SCSI ID Switch Settings C B A SCSI Address Switch Setting A B C Disk Module SCSI Addresses (Viewed from front of storage enclosure) 0 2 4 6 8 10 12 14 9 11 13 15 Note The disk system requires a terminator when it is installed at the end of the SCSI bus.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
HP StorageWorks Disk System 2100 / 2110
10
SCSI ID Switch
The SCSI ID switch sets the address for the disk drives.
There are three possible settings for the SCSI address switch: A, B, and C. Each
setting assigns a different
set
of addresses to the disk modules installed in the disk
system. For SCSI address switch setting A, the addresses for the installed disk
modules are (from left to right, looking at the disk system from the front) 0, 2, 4, and
6. For SCSI address switch setting B, the addresses for the installed disk modules are
8, 10, 12, and 14. For SCSI address switch setting C, the addresses for the installed
disk modules are 9, 11, 13, and 15. See Figure 5, below.
SCSI address 7 is reserved for use by the host bus adapter.
FIGURE 5
SCSI ID Switch Settings
Note
The disk system requires a terminator when it is installed at the end
of the SCSI bus.
0
8
9
2
10
11
4
12
13
6
14
15
A
B
C
SCSI
Address
Switch
Setting
Disk Module SCSI Addresses (Viewed from front of storage enclosure)
C
B
A