HP StorageWorks Disk System 2110 HP StorageWorks Disk System 2100/2110 User's - Page 13
Setting the SCSI IDs for the Disk Modules, Set the SCSI IDs.
View all HP StorageWorks Disk System 2110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
English HP StorageWorks Disk System 2100 / 2110 13 Setting the SCSI IDs for the Disk Modules 1 Determine which SCSI addresses are not being used on the host system. Refer to your system administration manual for information on determining which SCSI addresses are available on the host system. 2 Locate the SCSI switch on the back of the disk system. FIGURE 7 SCSI Switch Location C B A SCSI Address Switch Setting A B C Disk Module SCSI Addresses (Viewed from front of storage enclosure) 0 2 4 6 8 10 12 14 9 11 13 15 3 Set the SCSI IDs. Verify that the SCSI IDs you have chosen are available. If you are daisy-chaining these disk systems together, each SCSI ID switch must be set for a unique available set of SCSI IDs. TABLE 4 SCSI Switch Setting Definitions SCSI Switch Setting 1 A 0 B 8 C 9 Disk Slot 2 3 4 2 4 6 10 12 14 11 13 15