HP StorageWorks Modular Smart Array 1000 HP StorageWorks 1000 Modular Smart Ar - Page 12
Configuring Redundant Path, hwmgr -scan comp -clus, scu scan edt, from each node, show connections
View all HP StorageWorks Modular Smart Array 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Configuring Redundant Path Step Description Check 1 Connect the Fibre Channel cable from the new Fibre Channel HBA in the server to the F port on the HP SAN switch. 2 Connect the Fibre Channel cable from the new MSA controller to the port on the HP F SAN switch. 3 Configure the FC switch zoning to include the new MSA controller and new FC HBA (if F not already configured). 4 Create a new connection table on the disk array by performing one of the two F following commands from the Tru64 V5.1B operating system: # hwmgr -scan comp -clus # scu scan edt (from each node) 5 Verify that there is a connection from the MSA controller to the server HBA, and that F the host WWPN is the same as the WWPN of the Tru64 server. From the CLI of the second controller, enter: show connections Example display: CLI>show connections Connection Name: HBA1 Host WWNN=20000000-C93673BA Host WWPN=10000000-C93673BA Profile Name=Tru64 Connection Name: Host WWNN=50060B00-00225CB1 Host WWPN=50060B00-00225CB0 Profile Name=default The connection to the second controller displays default settings. 6 Assign a name and profile type to the connection (the additional HBA connected to the F second MSA array controller.) From the CLI, enter: add connection WWPN= profile= Example display assigning a connection name of HBA2: CLI>add connection HBA2 WWPN=50060B00-00225CB0 profile=Tru64 Connection has been added successfully. Profile Tru64 is set to the new connection. 12