HP StorageWorks SB40c HP StorageWorks SB40c Storage Blade Maintenance and Serv - Page 21

Hard drive blank, Hard drive

Get HP StorageWorks SB40c - Storage Blade PDF manuals and user guides View all HP StorageWorks SB40c manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

3. Lift the access panel latch and slide the access panel to the rear. 4. Remove the access panel. WARNING! To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to cool before touching them. CAUTION: To prevent damage to electrical components, properly ground the server blade before beginning any installation procedure. Improper grounding can cause ESD. To install the component: 1. Place the access panel on top of the SB40c with the hood latch open. Allow the panel to extend past the rear of the SB40c approximately 0.8 cm (0.2 in). 2. Engage the anchoring pin with the corresponding hole in the latch. 3. Push down on the hood latch. The access panel slides to a closed position. Hard drive blank 1. Remove the hard drive blank. 2. Replace the component by reversing the removal procedure. Hard drive 1. Determine the status of the hard drive from the hot-plug SAS hard drive LED combinations. 2. Back up all server data. 3. Remove the hard drive. HP StorageWorks SB40c Storage Blade 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
3.
Lift the access panel latch and slide the access panel to the rear.
4.
Remove the access panel.
WARNING!
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION:
To prevent damage to electrical components, properly ground the server blade before beginning any
installation procedure. Improper grounding can cause ESD.
To install the component:
1.
Place the access panel on top of the SB40c with the hood latch open. Allow the panel to extend
past the rear of the SB40c approximately 0.8 cm (0.2 in).
2.
Engage the anchoring pin with the corresponding hole in the latch.
3.
Push down on the hood latch. The access panel slides to a closed position.
Hard drive blank
1.
Remove the hard drive blank.
2.
Replace the component by reversing the removal procedure.
Hard drive
1.
Determine the status of the hard drive from the hot-plug SAS hard drive LED combinations.
2.
Back up all server data.
3.
Remove the hard drive.
HP StorageWorks SB40c Storage Blade
21