HP Stream 14-z000 HP Stream Notebook PC - Maintenance and Service Guide - Page 36

Power connector cable, Release the power connector cable from the retention clip

Get HP Stream 14-z000 PDF manuals and user guides View all HP Stream 14-z000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

Power connector cable Component Power connector cable Spare part number 759919-001 Before replacing the power connector cable, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the keyboard/top cover (see Keyboard/top cover on page 19). Remove the power connector cable: 1. Disconnect the power connector cable (1) from the system board. 2. Release the power connector cable from the retention clip (2) built into the base enclosure. 3. Release the power connector (3) and from the clip built into the base enclosure. 4. Remove the power connector cable. Reverse this procedure to install the power connector cable. 30 Chapter 4 Removal and replacement procedures for Authorized Service Provider parts

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
Power connector cable
Component
Spare part number
Power connector cable
759919-001
Before replacing the power connector cable, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the keyboard/top cover (see
Keyboard/top cover
on page
19
).
Remove the power connector cable:
1.
Disconnect the power connector cable
(1)
from the system board.
2.
Release the power connector cable from the retention clip
(2)
built into the base enclosure.
3.
Release the power connector
(3)
and from the clip built into the base enclosure.
4.
Remove the power connector cable.
Reverse this procedure to install the power connector cable.
30
Chapter 4
Removal and replacement procedures for Authorized Service Provider parts