HP Superdome SX2000 Installation Guide, Sixth Edition - HP Integrity Superdome - Page 57
MP Command Option, MP Virtual Front Panel
View all HP Superdome SX2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Figure 1-43 MP Command Option 5. In the another window, open the Virtual Front Panel (VFP) by entering vfp at the MP prompt (Figure 1-44). Use this window to observe partition status. Figure 1-44 MP Virtual Front Panel 6. From the VFP menu, enter s to select the whole system, or enter the partition number to select a particular partition. An output similar to Figure 1-45 appears. In this example, no status is listed because the system 48 V has not been switched on. Figure 1-45 Example of Partition State-Cabinet Not Powered Up Booting and Verifying the System 57
Figure 1-43 MP Command Option
5.
In the another window, open the Virtual Front Panel (VFP) by entering
vfp
at the MP prompt
(
Figure 1-44
). Use this window to observe partition status.
Figure 1-44 MP Virtual Front Panel
6.
From the VFP menu, enter
s
to select the whole system, or enter the partition number to
select a particular partition. An output similar to
Figure 1-45
appears. In this example, no
status is listed because the system 48 V has not been switched on.
Figure 1-45 Example of Partition State—Cabinet Not Powered Up
Booting and Verifying the System
57